Custom ELM327 OBD2 USB diagnostic cable for all Ford and Mazda models. Suitable for HS CAN and MS CAN protocols. Please note: Cable is supplied without software.
Suitable for o.a. the following Software:
FORScan
Elmconfig
FoCCCus
FF2
Basic features:
Read and clear error messages
Adjust the car configuration
Run tests
Oil/Service reset
Programming of various models of
List of supported modules (depending on the software):
FORScan software: http://forscan.org/modules_list.html
Pin configurations:
Switch position 1: HS CAN - Pin 6 and 14
Switch position 2: MS CAN - Pin 3 and 11
Modified ELM (English):
Please note that many Ford and Mazda models (approximately since 2003-2004) are equipped with MS CAN bus, in addition to the regular HS CAN bus. In contrast to HS CAN bus, MS CAN bus is not supported by the stock ELM327, because MS CAN is a manufacturer-specific solution and located on non-OBD2 pins. This ELM327 has been modified to allow it to implement the MS CAN bus.
ELM327 supports HS CAN from the stock, because Ford HS CAN completely matches to the OBD2 standards. It occupies pins 6 and 14. MS CAN bus occupies pins 3 and 11.